Search results for query: *

I have a soft spot for Dodge vans. We sold a ton of them at the dealership and some of them were really nice. Big comfy leather seats wood trim everywhere.

Sweet van!!!!

Same as this one

A leveling kit would have a thick spacer on the front coil.

I just went and looked at the f350 out back same set up same shocks. All stock as far as i know.

That is a factory block. Some Fords came with Rancho shocks too.

Pull a shock and take it to the parts store see how the length matches up.

I have to agree with you if its lifted its not much. Are the shocks an aftermarket brand? Sometimes they have a part number stamped in the body.

Any plumbing heating guys here have a recommendation on a gas hot water boiler? I was looking at a Laars Mascot FT Laars Mascot FT MFTCF199NA1XN Laars Floor Standing Combi Boiler.

I think that wire is supposed to be grounded to the front of the head. Look for a stud and nut with an eyelet that still on it.

The 2.7l engine can be rebuilt. I brought one back from sludged up timing chain jumped, and smashed valves. It takes sometime to get everything clean. What is wrong with the one you have?

It's a dam shame!!

Any luck getting it fixed??

A bad brake booster can give you a low pedal. Usually if you can pump up a good pedal it is air.

Maybe loose front wheel bearings pushing pads way back. Have seen wheel cylinders suck air in through the seals. Stuck caliper guide pins can give a low pedal. Pressure bleeding and properly bleeding the abs with a scan tool can make a big difference. I doubt it is the height valve as it really...

Ive seen the release fork break on a 99 ford with 6spd diesel.

The dakota has brackets that are part of the motor mounts. The brackets to do not come off and trap the cover. The way I do those is to leave it for the last thing to come off. I get the tranny ready to come out everything except the 2 big bell housing bolts that go through from the front. Then...

Put a hammer face bit in your air hammer and use it to rattle against the rotor between the studs all around the hub and they will pop off. Works every time.