Search results for query: *

Well I finally had time to work on the car again. I installed a new low/reverse piston, removed, checked and reinstalled the kick down piston. Adjusted the bands, disassembled, cleaned and reinstalled the valve body. Put the pan on, filled it full of fluid. Started the car and I now have...

I dropped the pan and the actuator piece had fallen out again. The servo piston is cracked, would this cause the actuator to fall out? Where is the best place to find a new piston, none of the local parts houses have it. What is the correct way for the actuator to go in since its rectangular?

I have a repair manual on the way and as soon as the SNOW melts and the weather warms back up (I don't have a heated garage) I'm going to drop the pan and start making some checks. Everyone is right, I don't want to pull the trans unless I have to. If there is a problem will the low/reverse...

Thanks for all of the help,I'm going to bite the bullet, buy a manual and pull the trans out. I'm tired of laying on my back trying to figure it out. Thanks again.

B&M floor shifter with a Lokar cable, we have adjusted it twice but I,ll check again. Could the forward band be out of adjustment and cause this problem?

We are finally are at a point where we can drive the car around the block. We started it, checked the fluids, put it in reverse and nothing. It does go into drive and the car will move. We put it on jack stands and in reverse the wheels didn't move, they turn in drive but the trans seemed to...

Will a posi carrier from a 9 1/4 rear fit/work in a 8 3/4 rear?? I have access to good working unit.

I,m not trying to thread jump but does anyone have pictures of the linkage? I'm also doing a 904 to 727 swap in a 72 Swinger. Thanks

Would it work with some mods? Since its an auto car I can locate the shifter hump where I need it. Looking at the diagram it looks like there is only a couple inches difference in the shifter location. What modification would be needed for the trans. mount? I would like to make it work if...

Will the 4 speed from a B-body fit/work in an A-body? I have the chance to buy a rebuilt running 360 w/4 speed for $700. I would like to put this in my 72 Swinger. The owner thinks the trans is from a B-body. Is the trans to long? Is the shifter location in the same place? My car was a /6 auto...

I am reassembling an 8 3/4 that was disassembled when I bought it. My question is are there 2 axle flange gaskets per side or 1? Are they both foam gaskets? I had to scrape a gasket that would be between the flange and backing plate but I don't remember a gasket between the backing plate and...