Search results for query: *

They are for SB. BB don't use them. There are different lengths so make sure you know which length you need. I'm not 100% sure but I think 318 and 340 are the same and 360 takes a longer one. Most people remove these when installing headers. They are usually in the way.

Course spline pinion yoke for 8 3/4 rear end. 7260 U-joint size. Located in Urbana, IA $30 OBO plus shipping. Free shipping to the Mopar Nationals if you want to pick it up there.

Brand new never used stainless steel trans lines from Fine Lines. These fit small block with 904 trans. I bought these for my 68 Dart project but they didn't end up fitting around the aftermarket shifter bracket that I'm going to use. I ended up buying Challenger lines since they are shaped...

Part# TTi340A-C5 Small block step headers...Polished ceramic coating with internal thermal barrier I bought these headers a few years ago for my 68 Dart project. They were installed on the engine for mock-up purposes ONLY and have NEVER been run. My Dart is going to sit very low to the ground...

SB or BB?

http://board.moparts.org/ubbthreads/upload2/8070854-P1020360.JPG

Yes, they are called "starter splash shields". On the E-bodies they were plastic and were only used on automatic cars. 4-speed cars weren't supposed to get them. Not sure if that applies to A-bodies as well. Only one is used per car. It mounts on the DS on the bottom of the frame rail. The...

Is this for sale? I haven't heard anything back.

I'll take it. How do you want payment?

PM sent

I've got a pair of those too. Mine are off of a 76 Charger. I'm not sure what else they would fit.