Search results for query: *

I can't easily measure the brackets without removing the seats. However, if you have the new seats it's pretty straightforward. You can see how I made them on my blog.

2009 Mini Cooper seats in my car. All manual adjustments, look vintage and hold you in place for corners. Link to my blog showing the brackets I made for them to fit. https://dartslantsix.wordpress.com/2018/06/29/carpet-and-new-seats/

Mine had the Plymouth symbol.

I was able to finish up the install. Used the Forever Sharp hub. Seems like a pretty nicely made piece. Only annoying thing is a small gap between the hub and column. And here's the wheel. I think it suits the car well. Really nicely made. Time will tell if I need an extra spacer...

I went ahead and ordered the Momo wheel plus the Forever Sharp adapter. I'll report back when it's all installed.

I found these 6-bolt adapters today: 6 Hole 2-Piece Adapter - Black 1967 PLYMOUTH BARRACUDA Volante STH1012 BLACK Volante 6-Bolt Steering Wheel Hub Adapters | Summit Racing Or this combo: 10-7012 GT3 Installation Hub, Chrysler Early Models, Polished - GT Performance Products 20-3006 GT3 Hub...

A lot of the newer reviews mention that they switched to a hard plastic instead of the foam grip. I don't really want to order it and find out it's hard plastic.

I am looking to put a better wheel into my 67 Barracuda. I would like a Tuff wheel, but stock ones with the adapter are very expensive. The Grant Tuff wheel sounds terrible from the recent reviews. Any other custom wheel look similar? 14-15" diameter. I found this Momo wheel: Retro that I...

My 67 Barracuda's turn signal lever has the plastic broken off. Can anyone tell me what years interchange? Or possibly other models, trucks, etc? Thanks.

Here's my setup: Gauge Upgrade I used a Speedhut gauge for the speedo, sunpro for the volts, and VDO for fuel. Haven't done a tach yet or the oil and Temp.

I want to buy a dash cap for my 67 Barracuda. I can't find them listed anywhere anymore (Dante's, Classic Ind). The only place I can find caps is Ebay and they are for a 68. Have they been discontinued? Will a 68 cap fit even though it won't look correct? Thanks.

My car has lights on the sides and a "map light" under the dash, but nothing in the center of the headliner.

2009 Mini Cooper seats in my Barracuda. My blog shows the brackets I made: Carpet and New Seats

Resurrecting this thread... These are 2009 Mini Cooper seats. Just got them installed with some brackets I fabbed up. They look vintage, flip forward for access to the back seat and are fully manual. Trying to decide if I should dye the piping black or keep it.

Installing 3-Point Seat-belts and a Headliner Here is what I did.

How did you mount this seat? I measured a set of 2016 Charger seats this weekend and the rails were too wide to fit on the passenger side, but could work on the driver's side. The passenger side is about 16" between the trans tunnel and the "hump" where the bench seat mounts. The seat rails on...

Eclipse seats are a good option. Thanks for that suggestion. The 300M seat look almost vintage, has anyone tried them? I installed Intrepid seats in a friend's Dart but it wouldn't fit on the passenger side without riding up on that bench seat hump area. Too wide, so we mounted it on that hump...

Mr. Shark- Can't help too much, but I was about to post this same question. I would be nice to compile a list of bucket seats that fit well in our A-bodies. One of the main issues I've run into is finding a seat that fits between the trans tunnel and the hump for the bench seat mount. I'm...