Search results for query: *

Thanks, that's what I was looking for, only thing I knew of the build was the 284/484 cam I chose

I cleaned them up, lol, but this engine only has about 3 hrs run time

These are the pistons on my 71 360, motor was done about 20 plus yrs ago, trying to figure out if they are low compression or not, I have no receipts or info since I traded the build for a truck, any help?

Rebuilt short block, new cam and lifters, its not a header leak, it has 0 miles on motor other than in my parking lot and break in

Ok here goes, I think I did a stupid mistake, I got a set of j heads sometime back, I took out the valves and put new ones in, no machining or anything, it has always ticked lick a bad lifter no matter what I do, I have 273 adjustable rockers, i've tried new springs, 2 sets of pushrods, 2 sets...

mating surfaces look good, so i should use cam assembly lube on the new lifters?

oil pressure 80 cold 30 hot, yes i soaked them, i just ordered a set of lunati lifters and called tech line they said not to soak them

cam looks ok, yes i measured for the corrct length, the lifters will not pump up

ok here goes, 71 340 motor with j heads, edelbrock rpm cam, 273 adustable rockers, had engine running but had ticking noise, found 273 pushrods to long, installed new shorter pushrods, noise was still there but not as bad, pulled lifters and they are not any good, ran this engine for about an...