Search results for query: *

I figured since this thing is getting a little age to it, and I had some extra tubing laying around, I would add a support brace.

Yes it is. I am getting ideas that I may incorporate into mine.

Lets see it. I like the bearings in mine. Makes turning the engine so easy.

Gonna be my one and only.

Has bearings in the engine mount rotissarie.

Thought I would share my home built combo. Had this for probably 30 years. Pulled and built lots of engines. Inline 6 to 429 Ford.

Just had to share this since you brought up Marquette products. I have one of their old 180 amp welders.

#6 it is then. Thanks.

Thanks for the info.

Has a 50 AMP plug. I picked up a 50 amp breaker. Now I just need to make sure of what gauge wire to use. I only need 8 feet or so.

My garage is part of the house. The breaker box is just on the other side of the wall. 4 foot up the wall and 4 foot right back down is all the wire being used to hook up the welder to the breaker box. The welder and air compressor will be the only thing on that breaker. They will not be used at...

I see your point now. I had it hooked up when I first got it home and it burned good on the few test passes I made. I think I may have had a 50 amp breaker on it but I couldn't remember for sure. I have had this welder for a long time an mostly use my mig welder. I need to hook this one up to...

I will be using 7014 rods.

I am not familiar with that term. Looking for a number .

It is old but works great.

This is exactly what I needed. Thanks for the info.

The dimension posted above weren't exactly what I was looking for. Anyone else. I am going to buy the tubing tomorrow and need some help.

I need the length from end to end of the legs that sit on the wheels. The length of the cross piece at the rear. Also the height from the top of the rear cross piece to the center of the engine mount plate.

Does anyone have an engine stand designed like this one that they could take 3 measurements for me? Click the link below. http://static.summitracing.com/global/images/prod/xlarge/sum-918014_oh_xl.jpg

Here you go Bob, click on the summit link. http://www.summitracing.com/parts/INO-3551 Supposed to be compatible with MSD and DIS ignitions.

Never mind I found one.

My timing light crapped out and I need to buy a new one. I am using an MSD 6 AL igniton box with factory electronic ignition distributor. What would be a good timng light to use with this? I have heard there are certain types to stay away from with MSD boxes. Not looking to buy an expensive one...

I kind of like this one. Would be easy to build and I can put it on the shelf or hang it up when I am done.

Here are some I found posted on another site.

I have heard of that being done. But with my luck it would fall out.

I am going to build a jig for 8 3/4 chunks. I want to learn to set up my own gears and need a jig to hold the chunk while I work on it. I want to see pictures of the one you have wether it is homebuilt or store bought.

Sounds like he might be looking for a very short torque wrench. If he is tightening the bolts like I do, the car is probably sitting on jack stands that aren't quite tall enough. I just put blue locktite on the bolts and tighten them with a closed end wrench with a little length on it so I can...