Search results for query: *

On my 76 Aspen I user rigid foam insulation board. You know the foil faced stuff.Used 1 in thick stuff and cut it to a tight fit then caulked it around the edges . Got tired of loosing things thru the rusted out quarters. It worked real well and actually looks decent when I open the trunk. Also...

They may be drain holes for water that may seep in around the glass

Yup , he used a 65 Barracuda dash in that 65 Dart .Here are the photos

I'm thinking now that the previous owner used a 65 barracuda S dash in that Dart I parted .It was a factory install for sure with a factory cut hole but the guy raced it and it had a 66 and up 4 speed trans in it. I'll see if I can dig out a photo.I parted this out in the 90's so. Bought it...

Yes they did . it is the exact same unit used in the Barracuda Formula S for 1965 . It mounts in the dash to the left of the instrument cluster. I parted out a 65 Dart GT with a commando 273 and a factory tach

As for the welds on the hump. They weren't neat from the factory and the way you can tell if it's original is to go under the car and look at the edge of the hole that was cut in the floor.It it is a saw cut it was added by someone .In the factory they used a cutting torch and you will see...

The 4 speed hump is right but totally butchered.The hole for the shifter should be round .The photo is a 65 hump with a 65 bezel the 64 is the same hump with just a round chrome trim ring around the rubber boot

The wiper switch is held on with a locking spring that just keeps it snug on the shaft .It pulls off .The headlight switch knob requires you to press the button on the body of the switch and while holding it down you pull on the knob ant it comes off with the shaft attached to the knob .to re...

That is the inside rear piece that goes next to the seat on a vert.My 66 Valiant vert has that same piece

Well you can make anything fit if you want it bad enough. What you will find is you end up with a wider gap between the seats or to much space between the seat and the door. If you punch your own holes in the floor it will work out much better than if you try to use either the outboard holes or...