Search results for query: *

I'll take anything for it. I just don't want to throw it in the trash if someone can use it.

A soft old beach towel works fine for me.

I am getting rid of this SBP KH setup to run a large pattern brake. I do not need to have the factory correct stuff so the restorer guys can probably better use these. What you see in the pictures is what I have at this time. The bearings are new but should be cleaned up. I believe the disks...

I have a black 05 Ram. It has been my daily driver since new, mileage now 141K. It has no water spots or swirls in the paint. I always wash my wheels, tires, and fenderwells first so I can keep water off the paint as long as possible to avoid it drying into waterspots. Then I blast it off with...

$35 including postage in US Offers may work too. Located in Waterford Michigan. Please send me a message as I may miss a post here.

25 hp ☆☆☆☆☆

eck.. i don't feel any vibration or anything, just don't like how it looks when running.. never used a clutch fan before though

Here’s one.

I wish I could do that. In Washington state unfortunately there is a lot of hills.

I did the swap on my boat, had a Chevy 350 in it…. But gained almost 5mph in a 4500 pound boat. So it’s worth something….

☆☆☆☆☆

Go down hill only...

You did an excellent job of describing your symptoms. It’s gotta be either the pump, the pickup or the lines between them. Make sure no lines are sucking air anywhere, look for wet spots on the rubber ones, and replace any rubber that has hardened up. Actually if you don’t have it already, use...

I had a bad clutch fan out of the box. Broke the housings on 3 water pumps before we found the actual problem.

$30 including postage in US. Offers may work too. Located in Waterford Michigan. Please send me a message as I may miss a post here.

Many recommend tack welding them.

My 241 has one too. Probably the same parts that are in my 273 dual point. In fact the distributor will probably interchange.

Crickets are deafening... "Only" 21 pages buried

tank is vented it has a vent port above the sending unit and i believe my gas cap is vented i can try the cap lose or just take it off so I don't lose it

Got a vented tank and or a vented gas cap? Try pulling the long hill with the gas cap loose. (Put a string on it so you don't loose it.) ☆☆☆☆☆

Thank you for all the detail

Finished putting the rear end together yesterday and today I put the wheels on. Problem is when I tried to torque the lug nuts, they would not tighten up. Looks like the studs are turning in the axle shaft flange holes. Had three nuts out of ten torque down. Pulled the axles back out to...

I will be thinking about Claire and hoping she will have a full and swift recovery. Charlie is doing really well, his appetite is back and he is getting around fine again. His arthritis is of course going to be a permanent issue, but as long as we keep the young one from jumping on him or...

$50 Including shipping in US. NOS Early A water bottle for ‘66 & I think ‘65 & ‘64. Offers may work too. Located in Waterford Michigan. Please send me a message as I may miss a post here.

full trim street 71 duster with a roll cage should be at 3300 pounds

Next: ☆☆☆☆☆

It was nice seeing the new owners that bought Pat’s semi survivor, early production 1968 Hemi Coronet R/T at the show. I didn’t take a pic while it was there, but they did put the blue line tires back on it.

Fantastic mph! What’s car weigh

As always looks good

I had the carb apart today i thought stuff was clogging it i didnt notice anything off with the floats. and the tank is full i had just filled it up before this happend and the hill is a decent hill its kinda long