Search results for query: *

I bought an edelbrock performer intake and was test fitting it last night. This intake doesn't cover the heat cross over. The square port below it is covered but not the round half circle opening. Did I buy the wrong intake or is there something else I have to do to cover this up? Thanks

I'm putting my 318 back together and I was wondering what bolts require the use of sealer on them? I would like to avoid leaks so I only have to do this once :) Thanks

actually i guess to be more correct this is actually about the nuts that go on the rods. I have been doing 'refresh' on a 318 and I pulled the rod ends off to inspect the bearings. When I was putting them back on I noticed that I had three nuts that were a different material they looked like...

I am going to be swapping my slant for a 318 that I have. It is out of a 75 pickup and has around 76k miles on it. This is a good running motor but also stock. I am doing the normal clean up paint and some new gaskets before putting it into my duster. I'm not sure how long I will keep this...