Search results for query: *

Just bought a clone Hemi car. It has dual Edelbrock #1405 carbs. Both chokes are inop. I would like to put a manual cable to the front carb. Edelbrock does not offer a manual kit for the the carb, imagine that! I talked with an Edelbrock tech, he gave me a possible bracket # 1494 and cable...

@318willrun. Deleted your email by mistake. Your in box is full. Did you say that there was something that I could do to richen my Carter 2-barrel? PM me. Greg. Quad Cities

How much fuel pressure will a Holley handle? I have had a problem trying to get a handle on my Sixpack jetting. Lean just driving around, stand on it and black plugs. That's with stock metering plates in the end carbs. Finally got an inline fuel pressure gauge and I have 10 lbs. I am...

Just replaced my fuel pump (Carter M6270) That's what was in it, no one seems to make a stock one. It's a mechanical for a '69 Dart, small block with six-pack. Has anyone had a problem with fittings? I could not stop the fuel leaks. It seems like they are 1/2-20 threads, but there was a...

Has anyone run an M6270 Carter fuel pump without a pressure regulator? Seem to be pretty limited on mechanical fuel pumps unless you want a chrome Holley or Edelbrock. I am running a Six pack and am trying to stay with stock fuel lines, would rather NOT have to use a regulator.

What eactly is this, and what does it do? Fancy fuel tank vent? Parts available? Just clean the bottom filter and go with it? The foam rubber on the inside doesn't look all that great. '72 Dart, 318

Where did I see a post for an electric heating element that would go into the cavity for the choke spring? I have Trickflow heads, no heat crossover. Small block six pack.

It seems like I have looked everywhere, but can not find the size of this metering plate for the end carbs # 34R-6153-B.

How do I identify what springs are in my vacuum pods? The six pack tune says black springs , mine are silver. Holleys website, they're all silver. Had these carbs gone through by a supposed expert, will not mention his name ( I should) and was quite disappointed when I received my...

Where exactly does this clip go? Clip 14-01-8 . What does it do, it was hanging on the shaft when I disassembled the assy. for blast and paint. Really wasn't doing anything, I believe that whoever assembled it the last time didn't know either. Hope the photo loads.