Search results for query: *

I would like to locate a solid driver quality A-Body. small block with A/C a plus. 67-72 Dart 70-72 Duster or Demon 2 door Valiant's and Scamps also considered. PM me. Thanks!

11.75 B-body pin style caliper adapters wanted. PM me here, Thanks!

Wanted! A pair of Keystone Klassic 15x7 or 15x8 in mint to NOS condition. Real original Keystones only no Cragar's. PM me here thanks

Edelbrock 2191 Performer 440 intake wanted, PM me here thanks

I need a passenger side 68-69 big block HP exhaust manifold. Heat riser is not important but must be repairable. I would also consider a 70-72 Thanks PM me here.

Like the title says, have a nice LD4B to trade or buy outright.

My Charger is DIW without this. I need the clip that holds the rod, #10 in the pic to the lower swivel bracket as circled. Thanks!

I need one of those large nuts that hold the trunk lock in on 73 - up Mopars. PM me, thanks!

Used 360 B&M flex plate for use with 904 and an internal balance converter needed. PM me Thanks, Jeff

I need 4 of the small sheet metal screws like the ones in the picture and one of the clips in order to install my splash shields, these are the later plastic type. PM me if yo have any, Thanks!

Need a 35 Orange, or 36 Red speedo gear. 35 preferred. PM me tahnks!

I need a seat belt set for a 76 Duster, these are the 3-point fronts with dual retractors and the long top pivot that hangs down. I really need the passenger one badly but would like to buy a complete set. 75 -76 Dart Sport and Duster should all be the same. PM me here thanks!

I need a set of nice shift rods for a a-body OD trans. PM me thanks

Parts needed for my 72 Demon Hood, preferably a 72 with provisions for the snorkel style scoop like in the picture. New England area so I can pick up. lower radiator support and right rad support. Vinyl top trim for the sail panels. I have the fronts. PM me here thanks!

I need a clean standard black steering wheel with a center cap for my 72 Demon. PM me, Thanks!

I am in need of a bunch of parts for my Demon. I know AMD makes most of the metal I need but if I can get nice oe stuff I would rather. For Sheetmetal I need: Both front floor pans, just the foot section left trunk extension left lower rear front fender patch trunk tire well patch. 4-speed...