Search results for query: *

OK, after having to get a complete rear axles rebuild, I drove the car home and all seemed well. When pulling onto the garage I turn the car off and blow the horn to alert the wife. The horns really didn't blow just made a low pitch weird sound. Strangely enough the volt gage almost pegged...

I think I want to move the coil from the horizontal position on the intake manifold to a vertical position to the left of the wiper motor on the firewall. I'm concerned the screws might hit the heater core. Any insight much appreciated.

Ok, I’m checking my electronic ignition system on my 72 Duster, 340. When checking voltage at the battery I got 12.43 volts. When I turn the ignition switch on I get 10.55 volts at input wire (disconnected from resistor) to the ballast resistor. With the wires connected to the resistor and the...

While driving my 72 Duster today I noted the Temp and Fuel gage Fluctuating. Could this be a voltage limiter issue? Thanks in advance.

The car has been idle in the garage for a couple weeks. When I fire it for a drive, I note the horn does not work. Checked all the connections at the horn and they are good. I think np it's the relay. Replaced the relay, still no horn. Any ideas? Thx Greg A

All, Having an issue with my new A body (70 Duster). The wiper motor looks new but when I turn it on, the wipers go from full down to about 2 inches up then full down and stop. I also noted that I can raise the wipers by hand about half way up the window and then they stop and I can push...

OK, I've been experiencing a number of ignition problems with my 72 Plymouth Duster 340. The latest problem is I only read 3.5 volts at the input to the coil. The ignition unit, ballast resistor, ignition switch and coil all have been replaced. Please HELP!!

OK, I got my recently restored instrument cluster and bezels back They look great but; 1. The parking brake light does not work. It did before. 2. The speedo has the shakes. It did not before. 3. I completely topped off the gas tank but the gage reads just short of full. It read full when...

Hello All, The few times I've driven my Duster at night I noticed that the heater/fan control does not illuminate. Since I've got the bezels and dash pad off I thought this would be a good time to check it out. Well I've looked everywhere and I don't any lamps in the area of the controls. Am...

All, I'm thinking about getting a Mopar period correct batteries with the red, green or yellow caps. Can someone tell which is correct for my 72 Duster 340. It was produced in Jun 72.

OK, the old bulb burned out so I thought no big deal. I replaced it but no go. Any ideas?