Search results for query: *

I am in process of installing exhaust in my 340 Demon. Up front I have Dougs Headers and I cam off those with a Dougs 3" X pipe. I bought the 2 1/2" custom over the axle tailpipes from Accurate exhaust to go on my chrome tips out the back. I wanted to do the 3" all the way including the...

I have my X pipe hooked to my headers. 3" pipes. They seem to fit fine in the two indents in the transmission crossmember. I am now trying to figure out where I need to locate and what size and shape mufflers? Do the mufflers just go up against the floor of the passenger area or further...

I already have the dougs heads on my 416 stroker motor. I recently picked up a dougs 3" Xpipe. Before I go ahead with this, I read that the 3" pipes are very hard to run all the way out to the rear? As an option I was thinking 3" Xpipe with mufflers and then changing to 2.5" after the...

I am uploading some pictures of the drivers side dougs headers with power steering. I did as shown in the pictures measured the dimensions from the kframe to the crank center and then the offset from the kframe bolt holes to the center which shows a 2.5" offset. Seems the dimensions look fine...

Can anybody tell me if I can get studs which are 5/16 coarse to go into my edelbrock aluminum heads and have the 3/8 fine thread to fill the holes in a stock 1970 340 manifolds for the nuts to go on. I have the two long tube nuts and they are 3/8" I don't see any in the ARP catalog unless I am...

Getting ready to purchase a set for the stroker. Parts guy says don't waste my money on a street stroker 470HP and just go with stock 340 iron. I had ceramic coating before and they sucked due to rusting. Warranty worked but the change over and return boxes also was a big pita. Some say the...