Search results for query: *

Just tried to install the rear axle brake line set. The drivers side piece seemed to fit pretty good but when I layed the passenger side piece up over the 8/3/4" hump into the clip the arc of the line fit the arc of the rear end perfect. Only problem is that the line is about 2" short of...

Does the Ebrake cable go over or under the gas line under the passenger front floor where that tightening rod is? Makes sense to me the cable should be under or closer to the street? I don't want to create any rub issues for that fuel line?

I am trying to put my park brake lever back in my car. It appears I have about four parts. One is a small bracket (square C shaped) and I can see where it gets a tab rotated through a slot in the frame and it has a nut and through bolt with it. In the book, they call it a clamp. The other is...

Anywone use the Allstar Performance Stainless braided brake line kits to plumb their front disc brake conversions. I had to swap calipers side for side because of my front sway bar and am looking at a part number 42027 braided line kit says for a big GM. It has a banjo fitting and bolt. The...

I am changing over the 72 Demon from drum to disc front brakes. I odered calipers from a 75 Dart Sport and I had to located them on the rear of the disc due to clearance issues with a factory installed sway bar which I do not want to compromise. I swapped the calipers sdie for side so the...

Hello, My Demon 340 car came with drim brakes all around. The brake master cylinder area was empty when I got the car. If it had drums all around, can I assume it was standard (non-power brakes)? I have upgraded to the LBP front discs and the larger rear drums for 15" wheels. My motor build is a...

Ok, I am just about done. Abody 72 Demon. Swap drum brakes for BBP disc brakes using 76 and up parts. Car had a OEM front sway bar so we mounted the calipers on the rear. I think what everyone is talking about regarding the bleeders is hopefully in the correct position. Without being...

I have a Raybestos RC4103 caliper. It is describes as a front left caliper. I am installing it on a conversion 72 Demon. I already installed the spindles and located them so the calipers face the rear as I have a factory sway bar and it appears these will hit the brackets which are located at...

Does anybody have some good clear pictures of the rear 10" x 2 1/2" rear brake install regarding the spring routing and ebrake setup. I know the longer shoe goes to the rear. The ebrake cable comes through the front of the backing plates. I have the ebrake actuator arm attached to the front...

Are the 10: rear backing plates the same for the 1 3/4" drums/shoes as the 2 1/2" drums/shoes? I am assuming that since the Abody 8 3/4 only came with the small bolt pattern and the 1 3/4" brakes, that the backing plates I will need to use to install the larger axles and the 2 1/2" brakes will...