Search results for query: *

Currently running a holley avenger 770. Holley website says I should be running an 870 cfm carb on a mild 416 stroker motor. My issue is that at idle my car seems to be running real rich when I smell the eye burning exhaust. Once I am underway it seems to clean itself up. I was thinking that...

I was just going to drill a 5/16" hole up high on my fuel neck and weld in a short 1" long piece of 5/16 fuel line so I can slide a rubber hose over it to make the bend to go back to hard pipe and down through the filler neck floor grommet out to the ground. Problem is that the fuel neck on my...

Just finished installing the dual exhaust in my Demon. Sitting out back of the car I noticed my recently installed empty gas tank seemed to be about an inch away from the right exhaust pipe and about three inches away from the left exhaust pipe. I have it just loosely installed and have not...

Having a hard time trying to get a fuel prebent fuel line for my 72 demon in 3/8"/ Ordered a right stuff one and it does not seem to fit too well? Year One lists 73-74 and 70-71 but skips over 72? Any one here have similar issues with pre bent lines?

I am trying to install a Holley 34-39 fuel log on my 340 stroker. 750 holley carb. It looks nice and clean which is what I wanted it to do, however, I am having issues with installing a filter. Seems a filter at the end projects out to far to take a turn and drop a line behind the...

bought a new tank for my 72 Demon from a tank company in Maryland. It seems to be a tight fit? Straps are not aligning with the indented grooves. Tank sits offset to the passenger side and almost toughing the inside of the frame rail while it has more space on the drivers side. I ordered a...

Was thinking about a fram 1 fuel filter. Should I run the fuel line into the mechanical pump and then out to the filter on the fenderwell and then across to the holley carb. Whats the cleanest way to do this. It is a 3/8 fuel line.

Looking at the Holley Ultra Black 750. Should I get mechanical or vacuum secondaries. I am building a 340/416 stroker motor. It will have 2.02 iron heads which will be mildly worked. Performer Air Gap, Headers, Lunati 276/513 cam, built 727, 3:55 gears, 27" tires,

Anybody got one on their stroker? Pictures. I was thinking about how this would perform and also a coooool look???