Search results for query: *

I am in the process of putting a PerTronix 1381-A on my 66 Newport. I would like to bypass the ballast resistor and use a PerTronix 40511 3.0 ohm coil. I have a MSD 8202 which has a primary resistance of 0.7 ohms and a secondary resistance of 4.5k ohms. Not being much of a electrical guru, I am...

I have a wiring gremlin somewhere. I will be driving the car and the car will act like its not getting any fire to the plugs, the tach needle begins to jump around and then the car dies. I can wait about 5-10 minutes and it will fire right up. It has also done this while idling in the garage...

I just recieved the October edition of Mopar Muscle magazine. There is a article on ballast resistors. Article states that with electronic ignition there is no need to use a ballast resistor. What are your thoughts on this?

Went outside to start the Dart today and all it did was turn over, no spark. So I pulled the #1 plug to confirm my suspicions. The only spark I get is when I first turn the key. I get one spark and thats it. Then when I release the key I sometimes get another spark. I`m stumped. Could it be the...

I need a photo or diagram of a stock fuse panel. I am looking for info. on what each fuse controls and proper amp. Thanks

I am having problems with my ignition module. I keep having to change the module after a couple of runs down the 1/4 mile. I will take one out and replace it with another and the same thing happens. The thing is I don`t think the modules are going bad, because after letting the one that quit...