Search results for query: *

Does anyone know when these heads are due out.

I have a roller cam LA head 360. I think it’s from around 1990, 1991 not sure. I don’t know much about these engines. I would like to step up to a bigger cam. Do I run a magnum style roller cam. And where can I find more info on these engines.

I recently purchased a 71 D100 that was converted from 6 to small block. I have noticed that at idle the balancer has a wobble. I checked for crank walk it seems good. When rotating the engine you can see it as it closes the gap with the timing marker almost touches then back to an 1/8 in gap. I...

I just lubed up a new cam with comp cams cam lube the runny red stuff left it for a couple days didn't install the lifters yet came back to install them and the cam is dry lube is gone. Not sure I have any faith in it. Where did it go I want to install lifters but the motors going to sit so I'm...

Hi, I am building a set of w2s and am wondering if I should run the stock size 3/8 diameter or go to the 11/32. For a motor that will not see more than 7200 rpm is there much gain for cost on the smaller diameter valve.

Anyone know the max rpm for a scat cast internal balance crank. Thanks

Anyone run edelbrocks out of the box with success. I here they need to be torn down and checked at the guides and seats. I want to run them in stages on my 340. Stock then port them. Thanks

I am forced to run a cast iron manifold that came on my 340. I am sure the block is decked. Pistons stick out about .020. Every manifold I have tried has not been able to seal at the bottom of the port. The top seems to be tight and the bottom has a gap. I not sure how I should measure to have...

Who has run this cam. I just installed one and it seems very docile. I replaced a comp cam 305-525 cam and this thing is very mild sounding. This is what I was looking for. Are these cams mild sounding compared to the 284-484 cams I have run. this is milder sounding. Thanks

Has anyone installed one of these. it uses three bolts, is there anything special to do when installing on a 340. Thanks

Does anyone have access to the head casting numbers for old W2 head castings. I need to know which head this casting numberis.3870810. If long valve or short, econo or race. Thanks