Search results for query: *

  1. gtmopar

    Got a Tranny Question for you guys

    Ok so I'm a little stumped to this one. I recently aquired a 99 Durango 4x4 5.9. I know the trannys are notorious for being temperamental so here's what it's doing. In drive just accelerating normally it goes through the gears fine. If you get on it even a little bit, 2nd gear goes away. So I...
  2. gtmopar

    Tranny Guys I Need Some Input

    So I just dropped the 904 in my 65 Dart this afternoon. It was a fairly good working tranny aside from the kickdown not working and it leaking from every gasket surface. So Im going to attempt to rebuild this tranny a little beefier to handle some horsepower. First off is this an early 904...
  3. gtmopar

    Rear axle install questions

    So I recently had my 8 3/4 narrowed and got new moser axles for it. I have a couple of questions. First is how far back do you need to drive the seal into the axle tube? I've got it in and pounded back to where the spacer and race should clear. Second off, I went with standard bearings which I...
  4. gtmopar

    904 not kicking down.

    Can't get this damn thing to kick down. I adjusted the kickdown to where at full throttle the arm on the tranny gets pushed back almost as far as it will go. What am I doing wrong or what else should I look for. Thanks for the imput.
  5. gtmopar

    Don't use these a$&holes!!!!

    Worst experience with an auto repair business in years. Had a rear end housing shortened and moser axles ordered by JAWS GEAR AND AXLE of Sacramento. After about 2 weeks I called and the employee said they weren't there. After another week I called and they said it could take over a month. Then...
  6. gtmopar

    904 issue

    Lookin to pick up a cuda w/904 that lost reverse. What's a common issue that would cause that? Just doing some brainstorming before yanking it. It sopposeably has been sitting for a looooong time. Any thoughts appreciated.
  7. gtmopar

    What's a good 727 rebuild kit for the money

    Going to tackle a rebuild on my 727 and I know there are several out there on the market. It will see some strip use and probably north of 550 hp it's going to need to handle. If more info is needed please let me know. Thanks
  8. gtmopar

    727 questions

    Hey guys hoping someone can shed some light on a couple of questions. I'm switching over to auto from 4 speed and I'm not up on auto equipped cars. Found a real nice 727 at swap meet that I'm going to tackle a rebuild job on. The guy I got it from said it came out of a early 70's motorhome with...
Back
Top