Search results for query: *

Car has not started on the first try lately and the tach reads correct and then bounces about a thousand low and then return back to the correct reading I knew there was a gremlin!! I got the car out and went to get gas and it didn't have spark to start at the gas station. Had to tow rope...

The two wires coming out of the distributor are a negative and postive. Which is positive and which is negative? I am purchasing: http://store.summitracing.com/partdetail.asp?part=SUM%2D850081&FROM=MG

I have had a pretty good ping at higher RPM foot to the floor and hitting it to the floor in general. I checked timing with the vacuum pluggged off and was still 18*idle, 34*@ 3200rpm (which is what my FBO distributor was curved to) but for kicks after checking the timing I hooked the vacuum up...

I just got a FBO Ignition kit and distributor using a FBO core. The vacum advance plate has some wobble. When I pulled it out of the packing the pickup was magneticlly attached to the reluctor. Not thinking the plate had a wobble I got my brass gage and went to set the air gap to .008 and found...

I replaced the turn signal switch and brake, turns and 4 ways work but now the backups are not working? this may be a unrelated coincidence? wiring diagram does not show they are related. no power getting to the tranny switch. tested tranny switch and it is good. no power coming from bulkhead to...

New harness has the contact pins that will push into the plug and because of them I can not fish them in to start it through. Even if I do get it started do I need to loosen the steering colum bracket down below because that seems awefully tight where the harness would come out? I spent 3...