Search results for query: *

Hey fellas, a while back I swear I had found a company that would modify your stock a833 side cover. They bored it and instead of using the single O-ring to seal the gear oil in I thought it was bored for a better lip seal. Also though they installed needle bearings for more support. Ive seen a...

So ive got some extra parts and 2 bolt on yoke a-body main shafts (i run a trunion style yet in my dart) that are in good shape except for some small rust pits on the bearing surface for the roller bearings that ride inside the input shaft. Anyone think welding them up & turning them down to...

Asking borg & beck style p.p. gurus. Ok Iive confirmed that rite @ about 2000-2500 rpm I can actually see the release fingers swing out & make contact with my release bearing! At idle its fine & I have the 1/ 12 free play in (dead space or take up) my clutch peadle until engine hits 2k on up you...

Anyone ever use any twin disc springless hub clutch's? I ask because I have a McLeod rxt twin 10 made for my stock 9 1/2 setup. Its is a no joke setup will not slip but my question is are thease guys common for slower shifting (more spinning weight on input shaft) also are they more prone for...

Well fellas as some of you know ive been working with Gary Seaward & Lee @ McLeod clutch to put together a "end all" clutch for us guy's & gal's who dont wanna change ove r to the 10.5 set up/fab parts to work. McLeod has done it! Im working with them to get this ava in the catalog to! I used...

Hey guys need som help! Why the f@$k! Is my fresh 1965 833 when it gets warm & cruising for a while it puks gear oil from the vent!?!?!?!?! Its not over full I don't understand it? Wrong fluid? It jas g-l5 80-w90 valvoline gear oil in it. HELP!

Hey all, im getting parts lined up to install a 65 4-speed in my 65 dart gt with a heathy 273. My qustion is has any of you early a-guys ran or tried this RAM clutch at all? Got all early a parts bell, flywheel & rekated parts. Don't wana halfta go to 10.5 to prevent slippage if at possable...