Search results for query: *

Looking for a set of steel wheels in the small bolt pattern 15x7 and 6's. Located in eastern washington

Looking for the small kickdown rod that goes to the trans lever on a 67 Dart w/slant six console shift. Not sure if there is a difference between console and column shifters. Thanks. Dean

Looking for a good cond edelbrock or carter version 500. Tired of the holley 390 need an upgrade.

Looking for asset of copper dash vents and the hoses that go with.

Looking for a decent rear bumper for a 67 dart with no major dings or dents, something suitable for a daily driver that looks good or a recommendation for repairing my current one. Also looking for a dash frame to experiment with.

Looking for a radio/heater bezel that's one piece for my 67 dart with the round radio knobs. All my nubs on the back are broke. Appearance not to important as I'm going to paint it.

Looking for one of these for my 67 dart with the mounting tabs on the back. I have some arm rest bases, pads ,and a couple marker lights I would trade.

looking for headrest assemblies for a 67 dart buckets.

Looking for the plate/bracket that holds heater core to firewall on a 67 dart.

I'm looking for a throttle cable for my 67 Dart 27-29" or longer is ok.

So my offy intake I discovered has a crack on the inside that apparently goes all the way through. leaks all under. Not particular on the brand just want to get this car running.

The end of my 67 Dart antenna that plugs into the radio corroded through and I replaced it but the plastic melted and the replacement end came off also. Just looking to replace the unit since I'm not having luck repairing it and I'm afraid of making the wire to short with further repairs. Not...

Looking for a pair of side mirrors for my 67 dart no remote. Glass fell out of the drivers side n didn't survive and replacement looks like crap

Looking for an electronic ignition distributor for my slant. I need a factory unit only.

Looking for a pair of the blower motor nuts with the washer attached for a 67 Dart

My glass dropped out and broke need to replace it. I would like to get a pair if possible.

Looking for the passenger side spindle for small bolt pattern disc. Threads are stripped.

Looking for the lower steel prebent brake lines for the early disc set up. Going on a 67 dart. These are the ones from the caliper to the rubber line I really only need the pass side but if someone has a set I'm up the pair.

Looking for headers for my slant prefer duals but whatcha got. Thanks. Dean

Looking for the last item to complete my brake swap. I have the KH brakes looking for the dist/prop block or valve or whatever its called to replace the drum/drum unit.

Looking for a 67 dart front half mainly heater box. Broke mine at the last hidden clip.

Looking for a slant header in good cond doesn't have to be perfect. I have a 383/400 torker new with a holley 600 id be willing to trade. In Eastern Washington.

I'm looking for the bottom strips that go with the 67 gt trunk trim, just the 2 narrow pieces are all I need. Thanks. Dean

I'm needing the nuts and washers for a 67 dart knob style radio to mount into the dash.

I'm again looking for a front hub for a 67 dart with the smaller center. Prefer right hand studs if available. To the members who offered last time I asked I got my hub off the drum this is the other side. I had cleaned out my message box and lost your pm's.

Good Day, I'm looing for a hub for my 67 darts front drum. Hub dia about 2.31 the hub opening on the finned earlier drums are to small for my wheels.

Looking for my early 67 Dart non remote outside mirror and rear view base-cracked the threaded area inside. Thanks. Dean

I need the bolt on timing cover tab for a 65 timing cover.

Looking for a set of main and rod bearings .010 for a 225.

I keep remembering after I put these in. Looking for a 67 dart gt radio dash bezel (I think that's what its called) for the round knobs.