Rogerdodger
Active Member
Good evening to all. Question; I have purchased 2 sets of rear bumper guards for my 1968 dart. Neither set for the rear match up with the bolt hole in the bumper. I have added pictures. Notice the top of the guard matched the bumper but flares out almost 1/2 inch at the bottom. Also the mounting bolt is higher up on the guard than the hole in the bumper by about 1 and 1/2 inch. Do I have the wrong guards or is it possible I have the wrong bumper on this beast? I measured from the inside of the guard to the hole as you can see by the pictures. If anyone has one of these lying around and can measure it I would greatly appreciated. Thanks to all!!!