1976 6 cylinder replaced with 340 front end riding low need ball joints - suggestions?

[jb123]

i took out the 6 and put in a 340. I need ball joints and the front is a little low. Any suggestions on how to handle the situation? replacing joints is a no brainer. i am wondering if the 6 cylinder ride height adjustment/ torsion etc......... will be able to raise the front end a little? New springs?

Anyway if anyone has done the 6 to 340 swap and used the old k member with the smaller torsion setup etc.......... whats up?

JB

 

[RedFish]

You can adjust the ride height with torsion bar adjust screws. It doesn't change or improve the spring rate like larger bars would.

 

[jb123]

I think its that simple....... just rebuild all the bushings joints etc........ and tighten the ride height adjustment bolts to lift up........... Thanks