SSG_Karg
Enhanced member
I'm ready to begin my stroker build and was looking for a little advice/tricks from some of you guys that have built them. Here's what I'm working with:
'70 340 block bored .060 over
4" forged eagle crank
eagle SIR rods
flat top pistons
W2 race heads with mild porting and 2.09/1.60 valves
Mainly I'm looking for thoughts on intake manifold, rockers, carb and any little tricks or pitfalls to watch out for. Going into '72 Duster 4speed, 3.91 SG, 29/12.50 tire, 3200lbs. Mainly used for weekend cruise-ins(showing off) and the occasional pass on the 1/4.
'70 340 block bored .060 over
4" forged eagle crank
eagle SIR rods
flat top pistons
W2 race heads with mild porting and 2.09/1.60 valves
Mainly I'm looking for thoughts on intake manifold, rockers, carb and any little tricks or pitfalls to watch out for. Going into '72 Duster 4speed, 3.91 SG, 29/12.50 tire, 3200lbs. Mainly used for weekend cruise-ins(showing off) and the occasional pass on the 1/4.
