360 edlebrock head rocker arm/push rods

[doopdoop67]

Hi guys I just bought the edlebrock power package for my 360 I’m having built. I don’t know what to do for rockers and push rods? Any recommendations? I found these Speedmaster PCE261.1181: Mopar Chrysler SB 318 340 360 1.5 Stainless Steel Roller Rocker Arms W/ Hardware | JEGS

 

[Wyrmrider]

go to b3 and read all four tech articles
http://www.b3racingengines.com/techcorner.asp
add the price of a b3 kit to those arms and pushrods otherwise the roller tips throw your geometry way off
for most builds iron rockers make a lot more dollars and sense
for lower lift builds stock rockers work fine
use hollow pushrods to help lube the adjusters or cps and pushrod ends

 

[318willrun]

Hi guys I just bought the edlebrock power package for my 360 I’m having built. I don’t know what to do for rockers and push rods? Any recommendations? I found these Speedmaster PCE261.1181: Mopar Chrysler SB 318 340 360 1.5 Stainless Steel Roller Rocker Arms W/ Hardware | JEGS

you can use stock rocker arms/shaft ….. though I wouldn't recommend if over .525 lift and tons of spring pressure

 

[doopdoop67]

you can use stock rocker arms/shaft ….. though I wouldn't recommend if over .525 lift and tons of spring pressure

That’s good to know thanks, how about push rods?

 

[318willrun]

That’s good to know thanks, how about push rods?

I think they may work, but you may have to measure. Again, I wouldn't put any more than 125 lbs of seat pressure on a stock rocker, and keep it around .500 lift or less.