4 speed clutch pressure plate recommendations

[ike61]

Howdy. Im starting to gather parts for my valiant. Looking for recommendations on a clutch and pressure plate. Here is what i have.

1964 valiant, 400 horsepower or so 360, 323 gears. Probably will never race it, but want something reliable and durable. Thanks

 

[340Dart]

I run a Ram Powergrip HD clutch in mine. Best one out of all the ones I ran. Been in my car for over 10 years. Few runs at the track and mostly street. No problems at all.

 

[Dan Brewer]

What bellhousing/flywheel are you using? Any preference between Borg & Beck and a softer diaphragm style pp?

 

[lemondana]

I found a NOS Schiefer B&B 3000 lb pp for my 68 340 Dart, with my bad knees, I can hardly push it in

 

[matthon]

I had a B&B with the overcenter spring, worked well but you had to give it a good push.

Replaced it with a Centerforce pp/clutch/bearing/flywheel, removed the spring, easy peasy no complaints.

After many years, removed it for a trans swap and just assumed it might need to be replaced so I ordered all new again. Turns out the clutch was just as thick with material as the new one.

Liked it so much put the same in another car.

 

[ike61]

10.5 factory bellhousing and factory flywheel that I have to have brewers balance

 

[Dan Brewer]

10.5 factory bellhousing and factory flywheel that I have to have brewers balance

If you are using an oem cast flywheel, this is the diaphragm clutch I would use at 400hp: Brewer's Performance - Mopar A833 4-Speed Transmission and Component Specialists

If you want to use B&B 3 finger: Ram-88773, it's not currently on our website. 10.9" x 23 for use on 11.625" bolt pattern. Full faced lining on both sides.