A 400 block that has had aluminum caps and main studs installed. Block was tanked, inspected then sent out for main cap installation. Caps were installed and line bored. Caps, machining, cleaning and tear down cost ran right at 950.
Good block as a base for a 400 stroker build. It is close to Brian at IMM so that is an ption if you are looking to have him build something. I also have a set of Victor Max wedge heads available.
$800 + shipping.
Block is located in Indio, CA
PM or email to robule1 at yahoo dot com
Good block as a base for a 400 stroker build. It is close to Brian at IMM so that is an ption if you are looking to have him build something. I also have a set of Victor Max wedge heads available.
$800 + shipping.
Block is located in Indio, CA
PM or email to robule1 at yahoo dot com
Last edited:
