As title states. Rods are 440 Source Replacement rods. Pistons are Arias forged, 1/16, 1/16, 3/16 ring pack. Bore is .030 over. Comp. Height is 1.955. Std. size pin. These were measured at .110 down in the hole. These came out of a customer's engine that was built by a different shop. Took all necessary precautions to insure proper flat tappet cam break in, which didn't go well. Selling these to go a different route on compression. Would work good for a low compression truck engine or mild turbo build. They only have 30 minutes of cam break in time, no dyno time. Asking $600.00, OBRO, plus the ride. PM me here. Located in NW Iowa. Thanks, FABO!!
