[SOLD] 499 stroker motor (built by IMM Engines)

[valiantsurf]

Hi I am selling my 499 CI stroked motor Dyno at 610 HP@ 5600 RPM 621 lbft @ 4800 RPM.
400 block bored .035 over with 440 source stroker kit, upgraded with ARP 2000 rod bolts. Victor intake port matched to Victor heads with hughes rockers on Cometic head gaskets.
MSD pro billet distributor, CSR electric water pump. I forget the brand of dampener, but it is stamped with SFI 18.1 approval. This motor was built for me at IMM engines 2 seasons ago and dyno'd, has been in my garage stored since. No carburetor, exhaust, plug wires, or flex plate provided.
$6,000 located Escondido, CA PM me or call (760) 644-8614
Thanks, Surf

 

[DARTGAME]

Will this run on pump gas?
Ian

 

[imdominant]

any partial trades?

 

[valiantsurf]

Sorry for delayed responses , I didn't have my notification set up correctly.
This will run on 91 octane just fine . Believe it was just under 10:1 compression with aluminum heads.

I will consider partial trades , cash is always best of course. I am going back to school so my money and time have become scarce! So I doubt I would be interested in major projects. I would consider partial trades for running big block raised or low deck of lesser build, narrowed Dana 60 (to factory a body length or very close to it) Or ?? Let me know what you have, worst I can say is no 😃

 

[davescuda]

what year is the Block?

 

[valiantsurf]

Sold