65 Barracuda

-
Status
Not open for further replies.

JRT

Well-Known Member
Joined
Jan 23, 2007
Messages
55
Reaction score
0
Rating - 0%
0   0   0
Contact seller
1965 Plymouth Barracuda project for sale. Car needs total restoration. Dimanteled. Have new fender patch panels, 1/4 panel patch panels, drivers side floorpan. six pack hood scoop. 4 speed hump. 8 3/4 rear, with surgrip chunk. 904 automatic transmission and crossmember. 318 block all mill work done(bored .30, lined honed and decked, with mains, and connecting rods)273 steel crank, of magnum heads. Engine is not together. All glass is good. This is a project but, I have alot of parts, will not part out. Your welcome to come and take a look. Do not have any pics at this time. National Park, NJ $2500 Nichorob2000@yahoo.com
 
hood fender doors and glass are out all the other parts (sheet metal block etc also off.
 
Correction rear glass is still in. still on all four wheels also.
 
I need this out of my garage $1500 firm. I will help you load everything.
 
65 Barracuda stripped down. Needs restored (rolling)
All glass is good
Have 90% of all trim peices
have 90% of the new sheet metal patches that need to be put on
Fender patches
1/4 panels
4 spd hump
drivers side floor pan
Fiberglasss 6-pack hood scoop
two deck lids
door panel patches etc.

Have 318 block with mill work done
Bored.30 decked, cam bearings installed and main caps.

Also have
273 crank
magnum heads
connecting rods

Also have 8 3/4 A-body rear (not in car)
suregrip chunk Not sure of gears 2:73 I think could be wrong. (You can change them out)
904 Tranny with crossmember.
$1500.00 (dirt cheap) I dont care if you buy it and part them out for more I just need to sell it and get out it of my garage. located in south jersey.
Nichorob2000@yahoo.com
 
Status
Not open for further replies.
-
Back
Top