'66 barracuda left hand thread wheel stud fixed

-
V

VividVisions

New Member
Joined
Apr 1, 2014
Messages
3
Reaction score
0
Location
Michigan
The story goes like this. I've never worked on a classic car till Bossman was inherited a '66 barracuda, just recently I noticed the tie rod ends were junk, and the shocks were very weak, in this process I figured taking the wheel off would make things much easier. I have never been schooled or knew of the left handed thread lug nuts on the driver side... yup, broke 2 of them before realizing this fact. So trying to find a fix was impossible besides trying to contact some people who have them laying around. Mistake #2... I pressed them out like a standard stud... didn't know about them swage locking?? Them... well the hub ended up being .590. They don't make a 7/16-20 RH stud for that fix. So me and Bossman put our brains to work and we came up with a 1/2-20 stud with a .609 knurl (610-481.1) and lucky for us I work and he owns a machine shop. Turned the stud down and threaded 7/16-20 LH and they pressed in like a gem. So if u think its the end of the world for your LH stud just find the right machine shop.

 
I just switched mine out with an extra passenger side one I had, then tapped out the rears and put RH ones on the part side as well!! Geof
 

That was a thought but since I was an idiot to the swage lock, I made the hole too big for any 7/16-20 stud to work, the biggest knurl we could find was .570. I also read many people wanting to keep the LH thread but have resorted to having to change em all out to RH thread
 
You must log in or register to reply here.
-
Back
Top Bottom