'67 Barracuda Rear Leaf Spring Lowering Kit

[MoparsRule]

I'm sure this has been covered ad nauseum, but can anyone give me a heads up on where I can get some 1/2" - 1" lowering blocks to put under my rear axle to lower the rear of my Barracuda?

OR, if that's not the best way to do it, any other ideas?

Thanks!!!!
David

 

[dart67]

I got 1'' lowering blocks from speedway motors

 

[72bluNblu]

AFCO makes them. Just get a set that has provisions to take care of the locating pins so the blocks don't slide out. They should fit over the pin on the spring side and have a pin to fit into that axle on the top.

As for the "best" way, that would be to have springs with the right arch. But if the blocks are 1" or smaller it's not a problem.

 

[Leadfoot]

Did you try turning your front hangers over?

 

[Lelo Dart]

Mopar: NEW A and E-Body Rear Leaf Spring Hangers Cuda Challenger AAR T/A R/T
These are better than lowering blocks and will lower your ride 1".

 

[72bluNblu]

Mopar: NEW A and E-Body Rear Leaf Spring Hangers Cuda Challenger AAR T/A R/T
These are better than lowering blocks and will lower your ride 1".

Except those have a 5/8" hole for the spring bolt. If he's got stock springs they have a 1/2" spring bolt.