68 383-S BARRACUDA...WHERE DOES THE CLIP FOR THE BRAKE WIRE GO?

[ph23vo]

IT RUNS DOWN UNDER THE WASHER BOTTLE TO THE PROPORTIONING VALVE...SHOULD HAVE A CLIP TO HOLD IT..ANYONE WITH A 68 BIG BLOCK A BODY THAT COULD LOOK? PROB GOES ON THE SCREW FOR THE HEAT SHIELD BUT WANT TO MAKE SURE... .ALSO NEED A NEUTRAL SAFETY HARNESS IN GOOD SHAPE..SAME ALL ENGINE JUST MUST BE FOR AN AUTOMATIC THANKS

 

[charles mill]

my 383 s has a proportioning stock set up and has wire that goes to dash 4 loss of pressure

 

[69 M-CODE CUDA]

Really hard to see in this pic, but this is where the clip for my '69 big block Abody was. You're right, it was at the top heat shield screw. I guarantee that this pic shows where it was from the factory, as this car had never been apart before this pic was taken.

 

[ph23vo]

thanks thats where i thought it went! appr the effort!...any chance you know anyone with a 68 auto trans neutral safety harness? 67 and 69 is different sadly.. thanks again@!