[FOR TRADE] '68 Charger project.

-
Status
Not open for further replies.

shark1010

Member
Joined
Oct 13, 2016
Messages
11
Reaction score
3
Location
Pittsburg, KS
Rating - 100%
1   0   0
Contact seller
Looking to see if anyone is interested in trading for my 68 Charger project that has been sitting too long.. I'm looking for something more complete as time is not in my favor.

All frames/Roof are all perfect. Will need new trunk pan/metal around rear windshield, I have both sail panels and deck filler from AMD. Floor pans are not bad, has been patched in two places in front pans. Lower rear quarter spots will need work with some other small common areas to these.

Rebuilt 727 trans... can also include a non-# 440 w/ full length headers. (original engine is gone). 440 had good compression numbers from a 50k mileage '74 RV. Newer driveshaft.
Dash, harness are complete with 150 speedo/tic-toc/radio and all.

Was an A/C car, (all still present) Power brake car/power steering.
Hood is in great shape. Deck lid is in good shape.
Torsion supports are in great shape.
Grill/headlight assembly and hood hinges have both been restored to perfect condition.

Have both front buckets which would need restored/recovered, rear seat would need to be recovered to be perfect but is in good shape.
Rear glass is out for repair but is in good shape. All door glass is great along with mechanics.
Car has four matching wheels and rolls easy. 8.3/4 Rear.

Car is primarily completely disassembled other than front suspension, rear end. Trim is all stored well and in good shape, most small parts are labeled in zip-lock bags.

Southeast Kansas, Clean title, Car mostly wears its original Burgundy paint. Can sand portions off to show all metal.

Front suspension has been completely rebuilt using all PST components down to the lower control arms.

Interested in things such as 67-74 a/b/e bodies, tributes/clone cars, 4-speed cars, and a few other things, No full out drag cars/motorcycles... but no I'm not expecting a 25k-30k car or anything.. I'm even fine with rollers, just not much on the bodywork side as I don't have the time nor space for it.

Any questions, just pm or leave it here!
It's a project and will require bodywork, but it is pretty complete other than interior soft goods/radiator. (I do have good hood, trunk lid, and such that is not pictured)

Had posted awhile back with nothing found that was in distance.

321799-5c08275032447d26da2c0465516067b4.jpg


321800-1d84244584e62e233f353f68b63ed811.jpg


321802-f5037436e294e32686e51d112021f0d9.jpg


321803-1000b79a9a9d64b89816fedca0f06c6c.jpg


321806-7765ffb244f2e66d2a7b7e73f60d249b.jpg


321807-6e8a4a76fa5896768ed8882561d94a9c.jpg


321808-8ecc1da50c890b84b959c7b0c0661402.jpg


FullSizeRender.jpg


IMG_0738.JPG
 
cool charger i have a running 68 Plymouth Satellite with a rebuilt 440 and 727 tranny new brakes new exhaust with MagnaFlow Mufflers new fuel tank sending unit.driver ...
1969 chevy c20 Factory 396 400 tranny Dana 60 nice truck runs and drives .... or how much cash thanks Gary
 
Status
Not open for further replies.
-
Back
Top