70 Swinger 340 Engine Throttle Bracket

-
D

Dodge 340

Member
Joined
Jan 12, 2020
Messages
9
Reaction score
1
Location
Pennsylvania
I have installed a 7576 Edelbrock intake with a 4160 Holley carb on my 340 engine. With the intake being higher, the throttle cable bracket sits too low and my throttle cable is at too much of an angle and will wear on my cable. I would also like to get a billet throttle bracket assembly with return spring but have not been able to find one that will work with my setup for Mopar. Does anybody have any suggestions or maybe you have done this?
 
First, you need the Chrysler throttle lever adapter for your carburetor. Was this car originally a 2 barrel? If so, you need a longer 4 barrel specific cable. If not, then you can just buy a taller cable bracket, or if you just want to get it going, spacers under the bracket where it bolts to the intake, with longer bolts.
 
You must log in or register to reply here.
-

Back
Top