72 Fuel Injected Duster FS

-
Status
Not open for further replies.
Welcome to FABO Dave, I hope your next project is another A body.

Great looking Duster=P~. Soembody will be getting a heck of a deal:thumleft:
 
Out of my league, but I would suggest some under hood pictures to strengthen you ad, especially with the EFI conversion.
 

Thanks for the comments guys. I have a Dart Sport that I was thinking of building up but that will be at a later date.

I also have a carbureted setup for the car with a dual plane Mopar manifold and a Holley 600 carb if someone would prefer to go that route.

The FI setup is a multiport Mopar single plane manifold so it does not have quite as much torque but it is much nicer to drive and easier on gas. I am using a Walbro 392 pump which should be good up to 500hp. I had plans on adding a couple turbos to this engine but that will have to wait for another project.

I should have pictures of the engine compartment up by the end of the day.

Dave
 
Thanks for the compliments! I have added some engine compartment images to the following site:

http://www.stealthwd.ca/duster-3.html

The injection setup alone includes:

- 255 lph high pressure fuel pump
- Adjustable high pressure regulator
- Innovate Motorsports LC1 Wideband oxygen sensor
- Mopar single plane multiport intake manifold
- Dodge throttle body
- 23 lb/hr injectors - I also have a set of 29 lb/hr injectors which
should be good for ~375hp
- TPS, IAT, CLT, MAP sensors
- Megasquirt II engine management with wiring harness

Dave
 
I am willing to trailer this car for free within 800km of Saskatoon if someone is interested.
 
Status
Not open for further replies.
-
Back
Top Bottom