8 1/4 contact pattern

[peelo57]

Hi.

Does this look ok contact pattern??

8 1/4 rear whith motive 3.2 gears
backlash is 0.01'' , guide says between 0.008 -0.012 is fine
shims are 0.04 thick
pinion is torqued to 25 inch pounds

my only consern is the lower part of the contact pattern is it too clear edge???
sorry about bad picks. i will take better tomorrow

 

[Supershafts]

The marking is light, put a lot of pressure on it and do it again, if the mark is in the same area on both sides, it should be ok

 

[peelo57]

thanks for the reply.

i ended up taking 0.01' of shim of (total 0.03' shim left).
otherwise same values and i got better patern, no sharp edges and centered on thooth.

now the rear is under car and first brake in drive was quiet.