wireweld
Well-Known Member
Setting up the center with new 4.10 gears and bearings. Set pinion preload to 25 inch pounds. Depth gauge said I needed .096 shims. After setting backlash and preload on carrier, backlash set at .006, and tightening cap bolts. I checked backlash and it was .005. the setup turns hard by hand . So I put a beam wrench on and it takes 5 to 9 ft/lbs to turn. Does this said right?
Forgot to add that the pattern is centered and deep enough.
Forgot to add that the pattern is centered and deep enough.