8-3/4 REAR AXLE SEAL INSTALL ??

-
I had a leak problem for years. find out I was using the smaller seal 8835S when I needed the 8659S for Flanges axles. The reason they need to go in tight, so they don,t spin on you.
 
RON REAGLE said:
I picked up another seal yesterday Timken part # 8695-S it measured 2.690 So I put it in the freezer overnight it did shrink a little maybe 2.685 but I don't feel it will be enough to solve my issue. I'll try a flap wheel inside the tube but I can't see any flaws or burrs inside the housing. Thanks to all of you trying to help. This site is the best.
Click to expand...
Make sure you are not going past the lip.
 
You must log in or register to reply here.
-

Back
Top