roccodart440
Well-Known Member
- Joined
- Apr 19, 2010
- Messages
- 6,810
- Reaction score
- 3,594
It’s best to measure and have your driveshaft cut to length or have one made. Too many variables.
X infinity
It’s best to measure and have your driveshaft cut to length or have one made. Too many variables.
exactly the answer I was looking for! thanks!!!!changing from a 8 3/4 to a Dana 60 we needed a drive shaft that was 1.22 inches shorter.....
That's when I was saying I put the half inch to 5/8's spacers to move my axle back for Tire clearance I had another 5/8 or so of play in my slip yoke and I was able not to have to shorten my drive shaft... Results May Vary according to how much extra play you have on your slip yoke...exactly the answer I was looking for! thanks!!!!