8.8 into a 1967 Dart GT Convertible

[WillK]

I’m in the process of putting a 8.8 ford explorer rear from a 2000 ford explorer into my 1967 dodge dart. I need to know what spring perch I need to buy and anything else I may need to make it work. I already have a Spartan locker for it. Ordering new brakes so everything will be new calipers rotors pads etc.. just not sure what else I will need to order or do to make it work. If anyone recommends the perches or any other parts please of possible include a link or part number etc so I can find it and order it. I contacted summit racing and told them what doing but they didn’t have any idea what part or parts would work.

 

[JDMopar]

If the axles tubes on the 8.8 are 3" tubes like an 8 3/4 or a Dana 60, order the ones in the link below. Remember though, you will have to make a bushing for the holes in the bottom of the perches that the center bolt for the springs to go thru. For some reason, Mopar Performance made the holes too big.
Mopar Performance Leaf Spring Perches - Free Shipping on Orders Over $109 at Summit Racing

 

[roger buetow]

I have a 66 valiant that I put a 8.8 in, I'm not sure if the under side is the same as a 67 but with 8 in. wheels and 8 in. x 26 in. tires I needed 6 in. back spacing to get the tires inside the quarters.