4mulaSvaliant
Well-Known Member
Hey guys, hope someone can help here.
I just finished putting the TF2 kit in my 904. The last part I had laying on the bench was the adjustment screw for the throttle pressure cam. In my OLD chiltons manual it says there is a chrysler tool that you use to depress the valve which acts as the correct spacer as well. The measurement I need is for the gap from the High spot on the cam to the depressed or "bottomed out" throttle pressure valve. I know it is in the neighborhood of 1/2" but I really would like to have this accurate, being I just went through the trouble of being super careful and precise with all the other trans procedures.
Hope somebody knows this one! thx :scratch:
I just finished putting the TF2 kit in my 904. The last part I had laying on the bench was the adjustment screw for the throttle pressure cam. In my OLD chiltons manual it says there is a chrysler tool that you use to depress the valve which acts as the correct spacer as well. The measurement I need is for the gap from the High spot on the cam to the depressed or "bottomed out" throttle pressure valve. I know it is in the neighborhood of 1/2" but I really would like to have this accurate, being I just went through the trouble of being super careful and precise with all the other trans procedures.
Hope somebody knows this one! thx :scratch:
