[Found!] A body .8 offset Shackles P4120075

[72DMag]

Hi, iIm in search of a body .8 offset shackles part number P4120075. I can pay by PayPal, venmo, or postal money order. I'm located in the pittsburgh pa area. Thanks

 

[burks440]

i have a set that came from a c body that has an offset but not schure just how much can measure if interested.

 

[72DMag]

@burks440 If they are in good shape and the offset I need then yes I'll be interested!! Thanks

 

[el5dart]

dont quote me but i think the most offset you can get is either 1/2 or 5/8 in reality. maybe someone else can verify

 

[el5dart]

read the desciption dr diff gives

Mopar A-Body 1/2" Spring Relocation Kit Offset Hangers & Shackles

 

[Locomotion]

A-body shackle bushing have smaller O.D. shackle bushings (7/8") than the other shackles - E, B, F, etc. (1")

Are the A-body shackle studs the same diameter or smaller than the other body styles?

I have a new offset E/B set but can't find loose A-body shackles or bushings to compare it to at the moment.

 

[burks440]

its a 1'' offsat

 

[famous bob]

Hi, iIm in search of a body .8 offset shackles part number P4120075. I can pay by PayPal, venmo, or postal money order. I'm located in the pittsburgh pa area. Thanks

this post should open a can of worms !!!!

 

[72DMag]

I see the can of worms opened. I should mention the reason I need these is to put b body springs in an f body. These r the shackles mentioned to use per mopar. If the .8 offset isn't true and it's really .5 inches than I guess that's what I need. Thanks everyone!!

@Locomotion The shackle studs are 9/16. Mopar calls for a body springs on an f body hence they r same size stud. Hope that helps

 

[trapster]

67-76 MOPAR A-BODY OFFSET REAR LEAF SPRING SHACKLES | eBay 1 inch offset should be close enough.

 

[Locomotion]

So if the shackle studs are the same between the bodies, then just the proper bushings (7/8" or 1") would need to be installed.

Did you settle on a shackle set because this is what I have available. Like new - installed & run a few times for a project that didn't work out.