[FOR SALE] A body dana 60

-
Status
Not open for further replies.
maxie

maxie

Well-Known Member
Joined
Sep 21, 2008
Messages
165
Reaction score
55
Location
new castle Indiana
Rating - 0%
0   0   0
Contact seller
A body Dana 60 rear end stock width, it was in my demon. Stock perch locations, 35 spline axles with 4.10 gears, 1/2-20 3 inch long screw in studs. Mark Williams 1350 yoke The rear end is complete minus the brakes. Will not ship, must be picked up in east central Indiana

$1800

IMG_0105 copy.png
 
I also have a new stamped steel non chrome rear cover that goes with it, I didn't care for the chrome
 
No it is not, it is a truck housing that was cut down to fit into a A body, I don't think a truck housing can be machined for a pinion snubber do to oil passages in that area of the casting. Moser and Strange both sell Danas machined in that area for a lot more money. I just purchased a new Moser 60 that was machined for pinion snubber, powder coated, 35 spline axles and a spool with no brakes for $2800
 
Status
Not open for further replies.
-

Back
Top