a body driveshaft

[75dust440]

Preferably out of an 727-8 3/4 car. But need a driveshaft. cell # 940-230-3975. Tommy

 

[66340SEDAN]

Why don't you get one made? I did for my 66 Valiant!

 

[rjsjea]

Agree.....by the time you found one out of a yard and shipped (oversized) it, you will probably be at the cost of a new one from a local shop. NEW is better than well used usually

 

[MoparGod]

I have one from a 72 Duster, it was a 4 speed with the 8 3/4 rear. I'll take $75.00 + the shipping.

E-mail if you want it - [email protected]

 

[whitey]

I got a bent one for $5, all I needed was the slip yoke. $20 for new universals, & $45 cut and balanced. look around.

 

[crackedback]

I have one from a 72 Duster, it was a 4 speed with the 8 3/4 rear. I'll take $75.00 + the shipping.

E-mail if you want it - [email protected]

Too long, IIRC. He needs a DS in the 45" range and that one should be about 49"

 

[Ace]

I don't trust 35-year-old drivetrain parts. As far as driveshafts go, weights get knocked off, welds crack, rust, whatever, anything can go wrong. Get a new one made for not much more and know it is stronger, balanced and will last.

 

[MoparGod]

Too long, IIRC. He needs a DS in the 45" range and that one should be about 49"

I also have the one from that 67 Convertible that was a 727, with the 8 3/4 rear. That one is 45.5 from end to end, and about 44.25" center to center on the U joints. Same price! 8)

 

[75dust440]

i found a guy with a big supply of mopar drive shafts near me after doing some searching. Thanks for the help, I think having one built is the only way.