a833 throw out bearing clip replacement in car

Discussion in 'Manual Transmission & Clutch Discussions' started by Slantsix64, Jun 12, 2018.

  1. Slantsix64

    Slantsix64 Well-Known Member

    Messages:
    740
    Likes Received:
    100
    Joined:
    May 11, 2014
    Location:
    SGV
    View My Photos
    Local Time:
    7:02 AM
    is it possible to replace the throw out bearing clip while the trans is in the car? it looks like it can be but, i am not sure.
     
  2. Slantsix64

    Slantsix64 Well-Known Member

    Messages:
    740
    Likes Received:
    100
    Joined:
    May 11, 2014
    Location:
    SGV
    View My Photos
    Local Time:
    7:02 AM
    its a 1968 4 speed a833
     
  3. Slantsix64

    Slantsix64 Well-Known Member

    Messages:
    740
    Likes Received:
    100
    Joined:
    May 11, 2014
    Location:
    SGV
    View My Photos
    Local Time:
    7:02 AM
    answer; yes it is possible.
     
    • Like Like x 1
    • Thanks! Thanks! x 1
    • Frnknsteen

      Frnknsteen FABO Gold Member FABO Gold Member

      Messages:
      284
      Likes Received:
      151
      Joined:
      May 26, 2011
      Location:
      Spencer, IN
      Local Time:
      8:02 AM
      That had to be a tight fit getting up in there through the inspection cover opening! Nice job! I would have thought you would have to pull the transmission.
       
    • Slantsix64

      Slantsix64 Well-Known Member

      Messages:
      740
      Likes Received:
      100
      Joined:
      May 11, 2014
      Location:
      SGV
      View My Photos
      Local Time:
      7:02 AM
      I was in doubt the whole time, but I know now why my dad that hammer for all these years lol.