alfonso's lancer

[alfonso]

so far new:
master cylinder
front wheel cylinders
left front drum
tranny filter
dimmer switch
5 1757013 tires
4 13 cragars mid 70's
1 turn signal bulb
classic wipers from napa

need to fine tune braking----done 3/16
front end rebuilt------done 3/16
4 shocks
tune up

carb is a holley 7484 2 barrel with a flapper valve?
is neat as hell never seen one
can i rebuild

new distributor or rebuild to elec
elec ignition
heater core
speedo cable --------- buy where?
gas gauge------------buy where?
door seals we knew before going into car wash but fun
need stinking badges hood and trunk
that is it so far

 

[alfonso]

put gabriel gas red ryders in front car became tall ,27" to ground from bottom of fender lip
and i put monroe airs in rear to level car out
using 175/70/13 Firestone 380 tires
never got around to using the ss rims
and found a used set of 13 " dayton wires with the spinner bolt on
has 2 of 4 hub kit and finding out about ordering the rest

 

[slantsixdan]

Pics of carb?

 

[alfonso]

i found it to be a one barrel holley

 

[slantsixdan]

#7584 is indeed a Holley model 1920. It is an aftermarket replacement "Economaster" version -- take a look down the throat and you'll see the annular-discharge venturi. Good for fuel economy and low-end torque; more restrictive at high RPMs. Might be jetted a little on the lean side; what do your spark plugs look like?

 

[alfonso]

:-si have not tuned it since i received it,ran so good
and will do this weekend.

 

[alfonso]

going to install today
new champion copper plus plugs
new napa lifetime wires
cap rotor condenser
new coil
yesterday
voltage regulator
and horn relay
twin horns and loud!
also have a carb rebuild kit for weekend

 

[slantsixdan]

Can't say you're on the right track with Chumpion spark plugs and NAPA plug wires. Tune-up parts and technique suggestions in this thread.

 

[alfonso]

dan thanks for info ,
will use what i installed for now. plug and wires.returning cap rotor points and condenser
and in search of
that clever hei mod of yours this weekend .
can you give me list of proper ignition parts to purchase?
and best to buy
as i am in limited budget and racing the gas prices
and doing all i can to make car more efficient.
and thanks for help here and in other forum
ps.
ordered motor mounts from Kanter
as i could not afford for this month the Poly mounts
i also replaced the the gabriels and air shocks which rode terrible and the gabriel froze on me on right side,it sat in my garage in a box new for 8 years and seal was shot when installed.
i guess there is a shelf life.
bought a complete set of classic ias eldebrocks
boy what a ride and color match

 

[slantsixdan]

can you give me list of proper ignition parts to purchase?

See linked thread.

bought a complete set of classic ias eldebrocks
boy what a ride and color match

Yep, I like those, too.