Anyone Using a Bloomer Rotating assembly

[IRISH RT]

Just planning out another Build as you will see from My other post,

Was going to go Scat crank 4 inch stroke and H Beam Rods

Then a Mate Told me about Bloomer Cranks , see they do heads also

Just want to know if anyone is using the 4.125 Stroke rotating assembly and is it an easy fit as regards to clearance etc ,

thanx in advance

 

[draginmopars]

I know the ? was about 4.125
I have 2 engines
446 / airwolf heads, and a 449 with Indy w-2 heads
both 4.250 stroke,
they both went together easy with just a slight notching of the bore bottoms for rod clearance

he will have the pistons custom built for YOUR block > deck height,
also for cam lift, type of cylinder head
No extra charge

 

[justinp61]

I have one of Rods 4.125" cranks in my 434. It measured great, the only issue is the crank keyway is 3 degrees off.

 

[superbeesrt8]

I did 1 of Rods 4.125 kits very nice motor went together very had no issues in balancing rods all ck out good would not hesitate buying another kit from Rod I did just buy a 3.79 crank from him for a short deck R3 and that crank was right on the money also

 

[75Sport]

My 4.125 was right on the money and the 1973 block required no notching with 6.125 Callie's rods with ARP cap bolts. Dan