'63GT
Well-Known Member
If you're looking for some aluminum Batten W2's, I've got good news, and bad news. Good news is, I have one. Bad news is, I have ONE.
I don't have any history on this head, as I obtained it through some horse trading.
They are Ported. I would estimate them to go over 340 cfm with ease.
2.08/1.60 w/ 11/32 stems Ports at gasket are 1.400 x 2.250 Dual bolt patterns on exh.
Number in red box "6751" (see pic)
Will need a surface (clean up), some scars from a failure, but nothing serious.
HEAD ONLY. I DON'T HAVE VALVES, OR ROCKERS. questions? please ask
$650 plus shipping of your choosing. (make offer)
I don't have any history on this head, as I obtained it through some horse trading.
They are Ported. I would estimate them to go over 340 cfm with ease.
2.08/1.60 w/ 11/32 stems Ports at gasket are 1.400 x 2.250 Dual bolt patterns on exh.
Number in red box "6751" (see pic)
Will need a surface (clean up), some scars from a failure, but nothing serious.
HEAD ONLY. I DON'T HAVE VALVES, OR ROCKERS. questions? please ask
$650 plus shipping of your choosing. (make offer)
Last edited:
