Can any one ID this part?

[Hyper_pak]

I am drawing a blank.
I have 2 of them, just don't know the application.
Flat steel plate about 5 inches long.
Two captive studs, two drilled holes.
Big block throttle cable part?

 

[TT5.9mag]

Reminds me of some kind of shifter bracket. But you said you have two of em so…..

 

[qkcuda]

Stan, that looks like my big block offset coil bracket. This is the best picture I have. I had to modify mine by slotting the one end.

 

[Professor Fate]

Okay, I'm going to go waaay out on a limb here and say it's a coil relocation bracket, most likely for a big block with a dual-feed carburetor (since the front line interferes with the stock coil mount) or possibly "big" distributor interference (ie: DUI)...

or

 

[Professor Fate]

Stan, that looks like my big block offset coil bracket. This is the best picture I have. I had to modify mine by slotting the one end.

View attachment 1716373949

Treed me!

 

[TrailBeast]

Looks like brackets for a seat back to me.

 

[niceolddart]

I'm with TrailBeast. They look like rear seat brackets, maybe for fold down seats, but they also don't look like factory made brackets either.

 

[rbkt65]

coil bracket

 

[TrailBeast]

coil bracket

And a spare just in case?

 

[Professor Fate]

And a spare just in case?

Why not? I've got entire spare engines... an extra coil bracket is small potatoes!
It could be a seat bracket, but assuming they're both identical then they'd be two from the same side- the opposite side should be a reflection of the other, if I'm not mistaken- so not a set?

 

[Hyper_pak]

Factory made.
I am thinking the coil bracket.
Thanks for the intel!

 

[qkcuda]

Check the hole spacing versus the stud spacing. If it is the coil bracket it should be exactly the same.

 

[jos51700]

If it's factory, it'll have numbers stamped in it.

 

[Bewy]

What post #12 said...